Fiberglass Supply Depot Inc. 4 Lb. Density Expanding Pour Foam, 2 Part Polyurethane Closed Cell Liquid Foam for Boat and Dock Flotation

Fiberglass Supply Depot 4 lb. Density Expanding Foam Kit: 2 Part Closed Cell Polyurethane Liquid Foam for Boat and Dock Flotation, Insulation,

• 4LB. Density polyurethane flotation Foam 1 Gallon Kit; Consists of 1/2 gallon of Part A and 1/2 gallon of Part B and produces 2 cubic feet.
• Once fully cured this foam can be laminated over with any type of polyester, epoxy or vinyl ester resin without melting.
• This 4LB density foam is suited well for most flotation applications that require more support than the 2LB offers.
• This foam is recommended to be used when supporting gas tanks and some deck areas.
• Choose this density if you feel that the foam will be required to withstand minor to moderate loads.

Fiberglass Supply Depot, Inc. 4 lb. density pourable urethane foam expands fast to fill underfloor cavities, flotation chambers, dock floats & more for maximum buoyancy & safety. This two-part liquid mix and pour foam for flotation and insulation has a simple 1:1 mix ratio that makes it easy to measure and easy to use. There’s no such thing as an unsinkable boat, but if the unthinkable happens, you can improve your chances of staying afloat. Density Flotation Foam is US Coast Guard approved (Regulation Number 33 CFR 183.114) for flotation, making it ideal for small runabouts, kayaks, canoes, personal watercraft, and pontoons. It provides 75 lbs. of flotation per mixed 2-Quart Kit, and 300 lbs. of flotation per mixed 2-Gallon Kit. Use it to fill cavities under decks, in forward collision spaces, in hull voids, and in empty compartments. This lightweight, rapidly expanding foam is easy to use, sets up quickly, and cures at room temperature so it’s perfect for a number of marine, aircraft, RV, industrial, and artistic uses, such as soundproofing, thermal insulating, and other non-structural applications. Mixed foam expands rapidly and tremendously by volume, so prep ahead of time and be ready to pour immediately after mixing. Before you start mixing, be sure to wear a proper respirator, eye protection, protective gloves, and be sure your work area is well-ventilated. This pourable liquid foam is easy to use, but it’ll stick to almost everything. To help avoid messes and ensure proper adhesion, clean & prep the work area before you start mixing the foam components. Once the resin and activator are combined, the rate of expansion varies greatly, depending on the temperature of the foam, ambient air, and work surface. The recommended temperature range is 75-80F, for proper expansion. Keep in mind that you have only 25 seconds to mix the foam before it starts expanding, so be ready!